SEMS Screws with Captive Spring Washer manufactured in Property Class 8.8 Steel (ISO 898-1 property class 8.8) are dimensioned to DIN 6900-4. The sections below give the mechanical and physical properties of the grade, its behavior in corrosive and elevated-temperature service, and the full size table.
Why Choose Property Class 8.8 Steel for SEMS Screws with Captive Spring Washer
The workhorse medium-carbon alloy class for structural joints. For sems screws with captive spring washer, this matters when requires plating (zinc) for corrosion protection is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 898-1 property class 8.8 |
|---|---|
| Magnetic response | Magnetic |
| Service temperature | commonly limited to approx. +300 °C; confirm against the coating and the load |
| Corrosion characteristic | Requires plating (zinc) for corrosion protection |
Corrosion Behavior in Service
Carbon and alloy steel sems screws with captive spring washer require a coating for corrosion protection. Zinc plating (with or without passivation) is the most common; hot-dip galvanizing is used for outdoor structural service; black-oxide is mainly a tarnish-prevention finish for tool-room use.
Comparable Grades
For SEMS Screws with Captive Spring Washer, class 10.9 or 12.9 is the comparable strength step. Move up when the joint preload approaches the proof load of the current class; move down when the joint is over-specified. For corrosion-critical service, switch to stainless A2 or A4.
Sizes of SEMS Screws with Captive Spring Washer Available in Property Class 8.8 Steel
| Thread size | Pitch (mm) | Head diameter dk (mm) | Head height k (mm) | Washer outer diameter (mm) | Cross recess | Common length range (mm) | Reference standard |
|---|---|---|---|---|---|---|---|
| M3 | 0.5 | 5.6 | 2.4 | 6.2 | PH1 / PZ1 | 5~30 | DIN 6900-4 |
| M4 | 0.7 | 8.0 | 3.1 | 8.0 | PH2 / PZ2 | 6~40 | DIN 6900-4 |
| M5 | 0.8 | 9.5 | 3.7 | 10.0 | PH2 / PZ2 | 8~50 | DIN 6900-4 |
| M6 | 1.0 | 12.0 | 4.6 | 12.2 | PH3 / PZ3 | 8~60 | DIN 6900-4 |
| M8 | 1.25 | 16.0 | 6.0 | 15.4 | PH4 / PZ4 | 10~60 | DIN 6900-4 |
| M10 | 1.5 | 20.0 | 7.5 | 18.4 | PH4 / PZ4 | 12~60 | DIN 6900-4 |
