Dimensional data for M10 Socket Nuts (Hex Drive, Round Body) to Trade series (round body socket nut), with the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M10 Dimensional Row (Trade series (round body socket nut))
| Thread size | Outer diameter (mm) | Nut height m (mm) | Hex socket s (mm) | Socket depth (mm) | Material | Finish | Note |
|---|---|---|---|---|---|---|---|
| M10 | 18.0 | 18.0 | 10.0 | 9.0 | Alloy steel | Black oxide | Fits 18 mm bore |
Spanner & Drive for M10 Socket Nuts (Hex Drive, Round Body)
The hex socket for M10 Socket Nuts (Hex Drive, Round Body) is shown in the spec table — use the matching Allen / hex key (an ISO 2936 hex key set covers the full range). For a one-off, a T-handle key and a calibrated arm will do. For a batch, the only way to get the same preload twice is a torque-controlled driver.
Tightening Torque for M10
| Class 8.8 (dry, ~µ 0.125) | ≈ 49 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 69 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 83 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M10
| Tensile stress area As (ISO 898-1) | 58 mm² |
|---|---|
| Proof load, class 8.8 | 34 kN |
| Proof load, class 10.9 | 48 kN |
| Proof load, class 12.9 | 56 kN |
| Min. ultimate tensile, class 8.8 | 46 kN |
Proof load = stress area × proof stress per ISO 898-1. Design joints so the working preload stays below the proof load of the selected class.
Installation Tips for M10 Socket Nuts (Hex Drive, Round Body)
- Use a quality Allen key fully seated in the socket — partial engagement is the most common cause of stripped sockets at this size.
- For countersunk and button-head variants, chamfer the through-hole to seat the head flush without preloading the head/shank fillet.
Mating Parts for M10
Pair M10 with the matching M10 bolt or screw, plus a M10 flat washer where required to distribute load on softer materials.
