Dimensional data for M10 T-Slot Nuts to DIN 508, with the drive and the installation notes for this type. Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M10 Dimensional Row (DIN 508)
| Size | T-slot width a (mm) | Nut width b (mm) | Total height h (mm) | Neck height k (mm) | Chamfer f (mm) | Reference standard |
|---|---|---|---|---|---|---|
| M10 | 12 | 18 | 14 | 7 | 2.5 | DIN 508 |
Spanner & Drive for M10 T-Slot Nuts
Drive geometry for M10 T-Slot Nuts is given by the row above; match the tool to the listed values.
Tightening Torque for M10
| Class 8.8 (dry, ~µ 0.125) | ≈ 49 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 69 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 83 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M10
| Tensile stress area As (ISO 898-1) | 58 mm² |
|---|---|
| Proof load, class 8.8 | 34 kN |
| Proof load, class 10.9 | 48 kN |
| Proof load, class 12.9 | 56 kN |
| Min. ultimate tensile, class 8.8 | 46 kN |
Proof load = stress area × proof stress per ISO 898-1. Design joints so the working preload stays below the proof load of the selected class.
Common Applications for M10 T-Slot Nuts
M10 T-Slot Nuts are commonly specified for general-purpose joints in machinery, fixturing and equipment frames.
Mating Parts for M10
Pair M10 with the matching M10 bolt or screw, plus a M10 flat washer where required to distribute load on softer materials.
When to Step Up or Down from M10
When the joint preload approaches the proof load of M10 class 8.8, step up to M12 class 8.8 (or move to M10 class 10.9). When the joint is over-specified, M8 often saves weight and cost without losing the safety margin.
