The M2 size of Thin Hex Nuts, Unchamfered is dimensioned by ISO 4036. The table below gives the dimensional row from the standard, followed by the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M2 Dimensional Row (ISO 4036)
| Size | Pitch P (mm) | Width across corners e (mm) | Nut height m (mm) | Width across flats s (mm) | Reference standard |
|---|---|---|---|---|---|
| M2 | 0.4 | 4.4 | 1.2 | 4.0 | ISO 4036 |
Spanner & Drive for M2 Thin Hex Nuts, Unchamfered
M2 Thin Hex Nuts, Unchamfered have a width across flats of 4.0 mm — fit a 4.0 mm open-ended spanner or socket. Prefer a 6-point socket over a 12-point: it loads the corners of the 4.0 mm hex far less, which matters on plated heads and on anything that will be re-used. Set preload with a torque wrench rather than by arm.
Tightening Torque for M2
| Class 8.8 (dry, ~µ 0.125) | ≈ 0.3 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 0.6 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M2
Nuts are graded to ISO 898-2 by the proof load the nut itself will hold (classes 04, 05, 5, 6, 8, 10 and 12), not by the 8.8 / 10.9 / 12.9 scale used for bolts. A class-8 nut is the correct mate for a class-8.8 bolt, and the joint is designed on the bolt, so no bolt-tension figure is quoted here.
Installation Tips for M2 Thin Hex Nuts, Unchamfered
- Use a 6-point socket where access allows — 12-point sockets are more prone to rounding the corners on smaller sizes.
- A flanged head is its own washer. Adding a flat one under it lifts the serrations clear of the surface they are meant to bite, which is the whole locking mechanism gone.
- At M2 the joint is sensitive to over-torque — use a torque-limiting driver and check the head doesn't bury into a softer counterpart.
Mating Parts for M2
Pair M2 with the matching M2 bolt or screw, plus a M2 flat washer where required to distribute load on softer materials.
Custom manufacturing · Made to drawing
Need thin hex nuts, unchamfered in a size this table does not list?
This page covers M2 thin hex nuts, unchamfered. Thread size is the obvious variable and rarely the interesting one — height for clearance, across-flats for the tool already in the cell, and the locking feature for the vibration actually present. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
