The M24 size of T-Slot Nuts is dimensioned by DIN 508. The table below gives the dimensional row from the standard, followed by the drive and the installation notes for this type.
M24 Dimensional Row (DIN 508)
| Size | T-slot width a (mm) | Nut width b (mm) | Total height h (mm) | Neck height k (mm) | Chamfer f (mm) | Reference standard |
|---|---|---|---|---|---|---|
| M24 | 28 | 44 | 36 | 18 | 4 | DIN 508 |
Spanner & Drive for M24 T-Slot Nuts
Drive geometry for M24 T-Slot Nuts is given by the row above; match the tool to the listed values.
Tightening Torque for M24
| Class 8.8 (dry, ~µ 0.125) | ≈ 710 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 1000 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 1200 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M24
| Tensile stress area As (ISO 898-1) | 353 mm² |
|---|---|
| Proof load, class 8.8 | 212 kN |
| Proof load, class 10.9 | 293 kN |
| Proof load, class 12.9 | 342 kN |
| Min. ultimate tensile, class 8.8 | 282 kN |
Proof load = stress area × proof stress per ISO 898-1. Design joints so the working preload stays below the proof load of the selected class.
Common Applications for M24 T-Slot Nuts
M24 T-Slot Nuts are commonly specified for structural joints, flange connections and heavy equipment foundations.
Installation Tips for M24 T-Slot Nuts
- At M24 the stretch in the bolt becomes the controlling factor — for critical joints, use angle-controlled or stretch-controlled tightening instead of pure torque.
Mating Parts for M24
Pair M24 with the matching M24 bolt or screw, plus a M24 flat washer where required to distribute load on softer materials.
