Dimensional data for M5 Socket Nuts (Hex Drive, Round Body) to Trade series (round body socket nut), with the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M5 Dimensional Row (Trade series (round body socket nut))
| Thread size | Outer diameter (mm) | Nut height m (mm) | Hex socket s (mm) | Socket depth (mm) | Material | Finish | Note |
|---|---|---|---|---|---|---|---|
| M5 | 10.0 | 10.0 | 5.0 | 4.5 | Alloy steel | Black oxide | Fits 10 mm bore |
Spanner & Drive for M5 Socket Nuts (Hex Drive, Round Body)
The hex socket for M5 Socket Nuts (Hex Drive, Round Body) is shown in the spec table — use the matching Allen / hex key (an ISO 2936 hex key set covers the full range). Ball-end keys are for reaching the screw, not for tightening it — finish on the plain end, and on production work use a torque-controlled driver.
Tightening Torque for M5
| Class 8.8 (dry, ~µ 0.125) | ≈ 5.9 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 8.7 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 10 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M5
Nuts are graded to ISO 898-2 by the proof load the nut itself will hold (classes 04, 05, 5, 6, 8, 10 and 12), not by the 8.8 / 10.9 / 12.9 scale used for bolts. A class-8 nut is the correct mate for a class-8.8 bolt, and the joint is designed on the bolt, so no bolt-tension figure is quoted here.
Installation Tips for M5 Socket Nuts (Hex Drive, Round Body)
- Use a quality Allen key fully seated in the socket — partial engagement is the most common cause of stripped sockets at this size.
- For countersunk and button-head variants, chamfer the through-hole to seat the head flush without preloading the head/shank fillet.
- At M5 the joint is sensitive to over-torque — use a torque-limiting driver and check the head doesn't bury into a softer counterpart.
Mating Parts for M5
Pair M5 with the matching M5 bolt or screw, plus a M5 flat washer where required to distribute load on softer materials.
Custom manufacturing · Made to drawing
Need socket nuts (hex drive, round body) in a size this table does not list?
This page covers M5 socket nuts (hex drive, round body). Height and across-flats are the two most often changed — a thinner nut for clearance, a larger hex for a tool that is already on the line. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
