The M6 size of Left-Hand Thread Hex Nuts is dimensioned by DIN 934. The table below gives the dimensional row from the standard, followed by the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M6 Dimensional Row (DIN 934)
| Thread size | Pitch (mm) | Across flats s (mm) | Across corners e (mm) | Nut height m (mm) | Thread direction | Reference standard |
|---|---|---|---|---|---|---|
| M6 | 1.0 | 10 | 11.05 | 5.0 | Left-hand | DIN 934 LH |
Spanner & Drive for M6 Left-Hand Thread Hex Nuts
Drive geometry for M6 Left-Hand Thread Hex Nuts is given by the row above; match the tool to the listed values.
Tightening Torque for M6
| Class 8.8 (dry, ~µ 0.125) | ≈ 10 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 15 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 17 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M6
Nuts are graded to ISO 898-2 by the proof load the nut itself will hold (classes 04, 05, 5, 6, 8, 10 and 12), not by the 8.8 / 10.9 / 12.9 scale used for bolts. A class-8 nut is the correct mate for a class-8.8 bolt, and the joint is designed on the bolt, so no bolt-tension figure is quoted here.
Mating Parts for M6
Pair M6 with the matching M6 bolt or screw, plus a M6 flat washer where required to distribute load on softer materials.
When to Step Up or Down from M6
When the joint preload approaches the proof load of M6 class 8.8, step up to M8 class 8.8 (or move to M6 class 10.9). When the joint is over-specified, M5 often saves weight and cost without losing the safety margin.
Custom manufacturing · Made to drawing
Need left-hand thread hex nuts in a size this table does not list?
This page covers M6 left-hand thread hex nuts. Thread, height, across-flats, property class, locking feature and flange form can all be varied, including thread sizes the standard series does not run to. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
