Specification summary of ISO 4026 as applied to swing bolt: the dimensions the standard fixes, the full size range supplied, and the related designations commonly cross-referenced.
ISO 4026 — Scope
ISO 4026 specifies the dimensional requirements for swing bolt — gb/t 77 / iso 4026 (series 020). Material, surface condition and any performance rating are set by separate documents specific to this part family — ISO 898-1 and ISO 898-2, which govern bolt and nut property classes, do not apply here.
Tolerance & Product Grades
Tolerances for swing bolt — gb/t 77 / iso 4026 (series 020) are given as limits on the individual dimensions in the table rather than as a fastener product grade. Where a general-tolerance class is cited on the drawing instead, it applies to the dimensions not otherwise toleranced.
Dimensions Specified by ISO 4026
| Thread size | Pitch (mm) | Ring outer dia D (mm) | Ring wire dia (mm) | Total length L (mm) | SWL (kg, axial) | Reference standard |
|---|---|---|---|---|---|---|
| M8 | 1.25 | 20 | 8 | 36 | 140 | DIN 580 / GB/T 825 |
| M10 | 1.5 | 25 | 10 | 45 | 230 | DIN 580 / GB/T 825 |
| M12 | 1.75 | 30 | 12 | 54 | 340 | DIN 580 / GB/T 825 |
| M16 | 2.0 | 35 | 14 | 63 | 700 | DIN 580 / GB/T 825 |
| M20 | 2.5 | 40 | 16 | 72 | 1200 | DIN 580 / GB/T 825 |
| M24 | 3.0 | 50 | 20 | 90 | 1800 | DIN 580 / GB/T 825 |
| M30 | 3.5 | 60 | 25 | 108 | 3200 | DIN 580 / GB/T 825 |
| M36 | 4.0 | 72 | 30 | 126 | 5000 | DIN 580 / GB/T 825 |
Equivalent Standards
Where direct equivalents exist (ISO ↔ DIN, ISO ↔ ASME), they are listed on the parent Swing Bolt — GB/T 77 / ISO 4026 (Series 020) page. Always confirm against the dimensions on this page, since some "equivalent" standards differ in tolerances and head geometry.
Companion Standards
ISO 4026 controls only the geometry of swing bolt — gb/t 77 / iso 4026 (series 020). Surface finish is governed by separate finish standards (for example ISO 4042 for electroplating), and corrosion testing by ISO 9227 (neutral salt spray). Mechanical performance is set by the standards specific to this part family, not by ISO 898-1 or ISO 898-2, which apply to bolts, screws and nuts.
