Application guide for Spiral-Wound Metal Gaskets to GB/T 4622 / ASME B16.20. The core duty of the type is load distribution and anti-loosening under a bolt or nut. The typical industries, the how-to-specify checklist, assembly practice and the exclusion cases are set out below. Stocked across roughly 15 to 150, they cover heavy and structural work.
Typical Applications for Spiral-Wound Metal Gasket — GB/T 4622 / ASME B16.20 (Series 090)
The most common settings where these are specified:
- Timber & soft materials: large-OD types that prevent pull-through.
- General machine building: fastening covers, brackets, motors and sub-assemblies on production equipment.
- Maintenance & repair (MRO): a stocked size for servicing existing plant where the original fastener spec must be matched.
- Fabrication & metalwork: bench and on-site assembly of steel frames, enclosures and weldments.
- Bolted structural joints: spreading load over soft or oversized holes and protecting the surface.
How to Specify Spiral-Wound Metal Gasket — GB/T 4622 / ASME B16.20 (Series 090) for Your Application
- Size: Match the nominal size to the mating thread or hole. This product spans 15–150; check the full table below for the exact dimensions of each size.
- Type & OD: Select flat for load spreading, spring/serrated for anti-loosening, or fender/large-OD for soft or oversized holes.
- Environment: For damp, coastal or chemical exposure prefer A4/316 stainless or a suitable coating; indoors, plated steel or A2 is usually sufficient.
- Standard: This product is supplied to GB/T 4622 / ASME B16.20. Quoting the standard on your order guarantees interchangeable dimensions between suppliers.
Installation & Assembly Practice
- Place the washer under the rotating element (usually the nut) so tightening does not score the surface.
- Chamfered-hole side of a hardened washer faces the bolt head fillet.
- On serrated-flange hardware, do not add a plain washer — it defeats the serrations.
Common Selection Mistakes with Spiral-Wound Metal Gasket — GB/T 4622 / ASME B16.20 (Series 090)
- Relying on a spring washer for locking on class 8.8+ joints — at high preload it flattens and adds nothing.
- Choosing an OD too small for soft material, so the head pulls through or embeds.
Where Spiral-Wound Metal Gasket — GB/T 4622 / ASME B16.20 (Series 090) Are Not the Right Choice
A washer does not replace a locking feature on its own in severe vibration, and a spring washer adds little clamp on high-strength joints.
Custom manufacturing · Made to drawing
Need a spiral-wound metal gasket outside the standard range?
Bore, outside diameter, thickness, temper and finish are the variables here — there is no thread to specify, so the fit and the bearing area are what the drawing has to pin down. Made by stamping or punching.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
