Material specification page for neoprene washers in A2 Stainless Steel. Covers the grade designation (ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70), corrosion and magnetic behavior, comparable grades and their trade-offs, and the sizes available to DIN 125 A.
Why Choose A2 Stainless Steel for Neoprene Washers
The most common stainless group for indoor and general outdoor fasteners. For neoprene washers, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Good general corrosion resistance |
Corrosion Behavior in Service
A2 (304) gives excellent atmospheric and most-water corrosion resistance and is the most common stainless for Neoprene Washers in indoor and general outdoor service. In chloride-bearing environments (marine air, road salt, swimming pools) consider stepping up to A4 (316).
Comparable Grades
For Neoprene Washers, the alternative stainless grade is A4 (316). A2 (304) suits general indoor and outdoor service; A4 (316) adds molybdenum for marine and chloride environments. Where higher strength matters more than corrosion, switch to plated alloy-steel class 8.8 or 10.9.
Using Stainless Fasteners in Aluminum
Stainless steel is more noble than aluminum, so in the presence of an electrolyte — rain, condensation, salt spray — the aluminum becomes the anode and corrodes at the joint. The effect is driven by the area ratio: a small stainless fastener in a large aluminum section is normally acceptable, while a large stainless fastener in thin aluminum is not. Where the joint is wet, isolate the two metals with a coated or nylon washer and a sealant, or specify an aluminum or coated fastener instead.
Sizes of Neoprene Washers Available in A2 Stainless Steel
| Thread size | Inner diameter d1 (mm) | Outer diameter d2 (mm) | Thickness s (mm) | Hardness (Shore A) | Temperature range (deg C) | Reference standard |
|---|---|---|---|---|---|---|
| M3 | 3.2 | 7 | 1.0 | 60 | -35 to +100 | DIN 125 A series |
| M4 | 4.3 | 9 | 1.5 | 60 | -35 to +100 | DIN 125 A series |
| M5 | 5.3 | 10 | 1.5 | 60 | -35 to +100 | DIN 125 A series |
| M6 | 6.4 | 12 | 2.0 | 60 | -35 to +100 | DIN 125 A series |
| M8 | 8.4 | 16 | 2.0 | 60 | -35 to +100 | DIN 125 A series |
| M10 | 10.5 | 20 | 3.0 | 60 | -35 to +100 | DIN 125 A series |
| M12 | 13 | 24 | 3.0 | 60 | -35 to +100 | DIN 125 A series |
| M16 | 17 | 30 | 3.0 | 60 | -35 to +100 | DIN 125 A series |
