Material page for screw-in camping ground anchors in A2 Stainless Steel (ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70). The sizes below are the ones we supply; there is no published dimensional standard for this article, so the table rather than a standard number is what to quote. Corrosion behaviour is good general corrosion resistance and the service range is approx. -200 °C to +400 °C, subject to the property class and the joint.
Why Choose A2 Stainless Steel for Screw-In Camping Ground Anchors
The most common stainless group for indoor and general outdoor fasteners. For screw-in camping ground anchors, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Good general corrosion resistance |
Corrosion Behavior in Service
A2 (304) gives excellent atmospheric and most-water corrosion resistance and is the most common stainless for Screw-In Camping Ground Anchors in indoor and general outdoor service. In chloride-bearing environments (marine air, road salt, swimming pools) consider stepping up to A4 (316).
Comparable Grades
For Screw-In Camping Ground Anchors, the alternative stainless grade is A4 (316). Choose A2 (304) for general use and A4 (316) wherever chlorides are present; the molybdenum in A4 is the whole difference. Remember that stainless is the corrosion answer, not the strength answer — for load, look at class 8.8 or 10.9 instead.
Using Stainless Fasteners in Aluminum
Stainless steel is more noble than aluminum, so with an electrolyte present — rain, condensation, salt spray — the aluminum becomes the anode and corrodes at the joint. Area ratio decides how bad it gets: a small stainless fastener in a large aluminum section is normally acceptable, a large stainless fastener in thin aluminum is not. Where the joint gets wet, isolate the metals with a coated or nylon washer and a sealant, or specify an aluminum or coated fastener instead.
Sizes of Screw-In Camping Ground Anchors Available in A2 Stainless Steel
| Anchor form | Length options (mm) | Shaft diameter (mm) | Flight diameter (mm) | Drive | Soil range | Material / limit |
|---|---|---|---|---|---|---|
| Junior | 275 | 16 mm hex | firm to hard | threaded steel | ||
| Pro | 300 / 315 | 10 | 25 | 16 or 19 mm hex | firm to medium | threaded steel |
| Pro I | 450 / 465 | 10 | 35 | 16 or 19 mm hex | soft to medium; grass-topped sand | threaded steel |
| Pro II | 600 / 615 | 10 | 35 | 16 or 19 mm hex | soft or loose sand | threaded steel |
| Lite | 400 | 19 mm hex | sand and soft-to-firm | nylon blend; not for heavy vertical loads |
Dimensions are independent of the material: every size above is available in A2 Stainless Steel.
Custom manufacturing · Made to drawing
Need this anchor & concrete fixing in a grade that is not listed?
A2 Stainless Steel is one of the grades the catalog describes. Embedment depth, thread size, body length and corrosion protection are the variables; capacity remains a concrete design value, not a property of the anchor alone. Made by hot forging or thread rolling.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.







