A2 Stainless Steel Structural Breakstem Blind Rivets are supplied to our own published dimensions — this is a trade-series article rather than one covered by a dimensional standard, so confirm the figures against the part you are replacing. The grade provides good general corrosion resistance and is largely non-magnetic; the practical service range is approx. -200 °C to +400 °C, subject to the property class and the joint.
Why Choose A2 Stainless Steel for Structural Breakstem Blind Rivets
The most common stainless group for indoor and general outdoor fasteners. For structural breakstem blind rivets, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Good general corrosion resistance |
Galvanic & Galling Considerations
For stainless structural breakstem blind rivets the compatibility question is galvanic rather than galling: joined to aluminum or galvanized steel in wet service, stainless drives corrosion of the less-noble metal. Isolate with a coating, sleeve or non-conductive washer where the joint sees moisture. Note also that stainless is softer than hardened carbon steel, so where the part carries a wear or shear duty, check the load against the grade before substituting.
Comparable Grades
For Structural Breakstem Blind Rivets, the alternative stainless grade is A4 (316). Choose A2 (304) for general use and A4 (316) wherever chlorides are present; the molybdenum in A4 is the whole difference. Remember that stainless is the corrosion answer, not the strength answer — for load, look at class 8.8 or 10.9 instead.
Using Stainless Fasteners in Aluminum
The galvanic couple here runs the wrong way: aluminum is the less noble metal, so it corrodes and the fastener does not. What governs the rate is the ratio of areas — a large anode and a small cathode is a tolerable combination, the reverse concentrates the attack into thin material around the hole. An isolating washer plus sealant breaks the circuit; where that is impractical, match the fastener to the substrate.
Sizes of Structural Breakstem Blind Rivets Available in A2 Stainless Steel
| Nominal diameter (mm) | Equivalent inch diameter | Grip type | Stem lock | Material options | Joint option |
|---|---|---|---|---|---|
| 4.8 | 3/16 | multi-grip structural | mechanically locked | aluminum alloy / steel / 304Cu-A2 / 316-A4 stainless | sealed-joint capable |
| 6.4 | 1/4 | multi-grip structural | mechanically locked | aluminum alloy / steel / 304Cu-A2 / 316-A4 stainless | sealed-joint capable |
| 10 | 3/8 | multi-grip structural | mechanically locked | aluminum alloy / steel / 304Cu-A2 / 316-A4 stainless | sealed-joint capable |
Dimensions are independent of the material: every size above is available in A2 Stainless Steel.
Custom manufacturing · Made to drawing
Need this rivet in a grade that is not listed?
A2 Stainless Steel is one of the grades the catalog describes. Grip range is what a special usually changes — a joint thickness that falls between two standard rivets. Made by cold heading or drawing.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
