Material page for channel brackets and fittings in A4 Stainless Steel (ISO 3506 group A4 (316 / 1.4401), commonly supplied A4-80). The sizes below are the ones we supply; there is no published dimensional standard for this article, so the table rather than a standard number is what to quote. Corrosion behaviour is superior, including marine and chloride environments and the service range is approx. -200 °C to +400 °C, subject to the property class and the joint.
Why Choose A4 Stainless Steel for Channel Brackets and Fittings
Specified for marine, coastal and chemical applications. For channel brackets and fittings, this matters when superior, including marine and chloride environments is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A4 (316 / 1.4401), commonly supplied A4-80 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Superior, including marine and chloride environments |
Corrosion Behavior in Service
A4 (316) adds 2–3% molybdenum to the A2 (304) composition, which dramatically improves resistance to chloride-pitting corrosion. For Channel Brackets and Fittings in marine, coastal, swimming-pool or food-processing environments, A4 is the default selection.
Comparable Grades
For Channel Brackets and Fittings, the alternative stainless grade is A2 (304). A2 (304) covers general indoor and outdoor service. A4 (316) adds molybdenum, which is what buys the chloride resistance for marine and de-icing-salt exposure. Where strength matters more than corrosion, plated alloy steel in class 8.8 or 10.9 is the swap to make.
Using Stainless Fasteners in Aluminum
Stainless steel is more noble than aluminum, so with an electrolyte present — rain, condensation, salt spray — the aluminum becomes the anode and corrodes at the joint. Area ratio decides how bad it gets: a small stainless fastener in a large aluminum section is normally acceptable, a large stainless fastener in thin aluminum is not. Where the joint gets wet, isolate the metals with a coated or nylon washer and a sealant, or specify an aluminum or coated fastener instead.
Sizes of Channel Brackets and Fittings Available in A4 Stainless Steel
| Fitting | Function | Fixed with | Finish options |
|---|---|---|---|
| 90-degree angle bracket | right-angle channel joint | channel nuts and hex bolts | pre-galvanized, hot-dip galvanized, stainless |
| flat plate fitting | splices two channels in line | channel nuts and hex bolts | pre-galvanized, hot-dip galvanized, stainless |
| gusseted angle | stiffens a right-angle joint under load | channel nuts and hex bolts | pre-galvanized, hot-dip galvanized |
| post base | anchors a channel upright to concrete | anchor bolts | hot-dip galvanized |
| beam clamp fitting | hangs channel from a structural beam | clamp and threaded rod | pre-galvanized, hot-dip galvanized |
| channel end cap | closes a cut channel end | push fit | plastic |
Dimensions are independent of the material: every size above is available in A4 Stainless Steel.
Custom manufacturing · Made to drawing
Need this support & bracket in a grade that is not listed?
A4 Stainless Steel is one of the grades the catalog describes. With no standard to depart from, the tolerance scheme is the specification — which dimensions are critical, and which are simply nominal. Made by milling or stamping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.







