Material page for grip rings (reinforced shaft retainers) in A4 Stainless Steel (ISO 3506 group A4 (316 / 1.4401), commonly supplied A4-80). The sizes below are the ones we supply; there is no published dimensional standard for this article, so the table rather than a standard number is what to quote. Corrosion behaviour is superior, including marine and chloride environments and the service range is approx. -200 °C to +400 °C, subject to the property class and the joint.
Why Choose A4 Stainless Steel for Grip Rings (Reinforced Shaft Retainers)
Specified for marine, coastal and chemical applications. For grip rings (reinforced shaft retainers), this matters when superior, including marine and chloride environments is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A4 (316 / 1.4401), commonly supplied A4-80 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Superior, including marine and chloride environments |
Corrosion Behavior in Service
A4 (316) adds 2–3% molybdenum to the A2 (304) composition, which dramatically improves resistance to chloride-pitting corrosion. For Grip Rings (Reinforced Shaft Retainers) in marine, coastal, swimming-pool or food-processing environments, A4 is the default selection.
Comparable Grades
For Grip Rings (Reinforced Shaft Retainers), the alternative stainless grade is A2 (304). The practical dividing line is chlorides: A2 (304) is fine until salt is involved, and A4 (316) exists for the cases where it is — coastal, marine and road-salt service. Neither reaches the strength of a plated class 8.8 or 10.9 fastener.
Using Stainless Fasteners in Aluminum
Stainless steel is more noble than aluminum, so with an electrolyte present — rain, condensation, salt spray — the aluminum becomes the anode and corrodes at the joint. Area ratio decides how bad it gets: a small stainless fastener in a large aluminum section is normally acceptable, a large stainless fastener in thin aluminum is not. Where the joint gets wet, isolate the metals with a coated or nylon washer and a sealant, or specify an aluminum or coated fastener instead.
Sizes of Grip Rings (Reinforced Shaft Retainers) Available in A4 Stainless Steel
| Form | Fits | Holds against | Installed with |
|---|---|---|---|
| reinforced grip ring | shaft groove | high rotational speed, vibration | circlip pliers or a pusher |
| heavy-duty grip ring | shaft groove | high thrust loads | circlip pliers |
| self-locking grip ring | plain shaft, no groove | moderate thrust, one direction | pushed on, not removable |
Dimensions are independent of the material: every size above is available in A4 Stainless Steel.
Custom manufacturing · Made to drawing
Need this retaining ring in a grade that is not listed?
A4 Stainless Steel is one of the grades the catalog describes. Temper and thickness set the thrust the ring will take, and both are specifiable against the load rather than picked from a table. Made by stamping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
