Property Class 12.9 Steel Push-Button Quick-Adjust Nuts are supplied to our own published dimensions — this is a trade-series article rather than one covered by a dimensional standard, so confirm the figures against the part you are replacing. The grade provides requires plating or black-oxide protection and is magnetic; the practical service range is commonly limited to approx. +300 °C; confirm against the coating and the load.
Why Choose Property Class 12.9 Steel for Push-Button Quick-Adjust Nuts
The highest common strength class, for high-load machine assembly. For push-button quick-adjust nuts, this matters when requires plating or black-oxide protection is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 898-1 property class 12.9 |
|---|---|
| Magnetic response | Magnetic |
| Service temperature | commonly limited to approx. +300 °C; confirm against the coating and the load |
| Corrosion characteristic | Requires plating or black-oxide protection |
Galvanic & Galling Considerations
For push-button quick-adjust nuts in steel, the dominant compatibility issue is hydrogen embrittlement at high property classes (10.9 and above) when electroplated. Plating must be followed by an appropriate baking treatment, or a non-electroplated finish (mechanical zinc, zinc flake) should be substituted.
Comparable Grades
For Push-Button Quick-Adjust Nuts, class 8.8 is the comparable strength step. Move up when the joint preload approaches the proof load of the current class; move down when the joint is over-specified. For corrosion-critical service, switch to stainless A2 or A4.
Sizes of Push-Button Quick-Adjust Nuts Available in Property Class 12.9 Steel
| For rod thread | Body width (mm) | Body height (mm) | Holding force (N, typical) | Holding vs standard nut | Operation | Material | Use |
|---|---|---|---|---|---|---|---|
| M8 | 32 | 18 | 2500 | approx. 25% | Push button | Zinc alloy body, steel half nut | Jigs, adjustable frames |
| M10 | 38 | 20 | 4000 | approx. 25% | Push button | Zinc alloy body, steel half nut | Jigs, adjustable frames |
| M12 | 44 | 24 | 6000 | approx. 25% | Push button | Zinc alloy body, steel half nut | Clamping rigs |
| M16 | 54 | 28 | 10000 | approx. 25% | Push button | Zinc alloy body, steel half nut | Clamping rigs |
Dimensions are independent of the material: every size above is available in Property Class 12.9 Steel.
Custom manufacturing · Made to drawing
Need this nut in a grade that is not listed?
Grade 12 9 Steel is one of the grades the catalog describes. Thread, height, across-flats, property class, locking feature and flange form can all be varied, including thread sizes the standard series does not run to. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
