Material page for sliding spring t-nuts for aluminium profile in Property Class 8.8 Steel (ISO 898-1 property class 8.8). The sizes below are the ones we supply; there is no published dimensional standard for this article, so the table rather than a standard number is what to quote. Corrosion behaviour is requires plating (zinc) for corrosion protection and the service range is commonly limited to approx. +300 °C; confirm against the coating and the load.
Why Choose Property Class 8.8 Steel for Sliding Spring T-Nuts for Aluminium Profile
The workhorse medium-carbon alloy class for structural joints. For sliding spring t-nuts for aluminium profile, this matters when requires plating (zinc) for corrosion protection is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 898-1 property class 8.8 |
|---|---|
| Magnetic response | Magnetic |
| Service temperature | commonly limited to approx. +300 °C; confirm against the coating and the load |
| Corrosion characteristic | Requires plating (zinc) for corrosion protection |
Corrosion Behavior in Service
Carbon and alloy steel sliding spring t-nuts for aluminium profile require a coating for corrosion protection. Zinc plating (with or without passivation) is the most common; hot-dip galvanizing is used for outdoor structural service; black-oxide is mainly a tarnish-prevention finish for tool-room use.
Comparable Grades
For Sliding Spring T-Nuts for Aluminium Profile, class 10.9 or 12.9 is the comparable strength step. Move up when the joint preload approaches the proof load of the current class; move down when the joint is over-specified. For corrosion-critical service, switch to stainless A2 or A4.
Sizes of Sliding Spring T-Nuts for Aluminium Profile Available in Property Class 8.8 Steel
| Profile series | Slot width (mm) | Thread size | Material | Anti-rotation |
|---|---|---|---|---|
| 20 | 6 | M3 / M4 / M5 | zinc-plated carbon steel or stainless steel | built-in spring clip |
| 30 | 8 | M4 / M5 / M6 | zinc-plated carbon steel or stainless steel | built-in spring clip |
| 40 | 8 or 10 | M5 / M6 / M8 | zinc-plated carbon steel or stainless steel | built-in spring clip |
| 45 | 10 | M6 / M8 | zinc-plated carbon steel or stainless steel | built-in spring clip |
Dimensions are independent of the material: every size above is available in Property Class 8.8 Steel.
Custom manufacturing · Made to drawing
Need this nut in a grade that is not listed?
Grade 8 8 Steel is one of the grades the catalog describes. Height and across-flats are the two most often changed — a thinner nut for clearance, a larger hex for a tool that is already on the line. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.







