Dimensional and assembly data for M0.6 Micro Miniature Small Pan-Head Phillips Machine Screws to Trade series (micro machine screws). Includes head size and width across flats, clearance-hole and tapping-drill diameters, tightening torque per property class, and the sizes to step up or down to when the joint requires it.
M0.6 Dimensional Row (Trade series (micro machine screws))
| Thread size | Head diameter (mm) | Head height (mm) | Typical length range (mm) | Drive | Material options |
|---|---|---|---|---|---|
| M0.6 | 1.2 | 0.35 | 2~20 | miniature cross recess | zinc-plated / black-plated / nickel-plated steel; A2/316 stainless; brass |
Spanner & Drive for M0.6 Micro Miniature Small Pan-Head Phillips Machine Screws
Drive geometry for M0.6 Micro Miniature Small Pan-Head Phillips Machine Screws is given by the row above; match the tool to the listed values.
M0.6 Micro Miniature Small Pan-Head Phillips Machine Screws Weight
A steel M0.6 micro miniature small pan-head phillips machine screws at the listed 220 mm length weighs approximately 0.5 g each — about 0.5 kg per 1,000 pieces. Stainless A2/A4 weighs roughly the same (density 7.9–8.0 g/cm³).
Actual weight varies slightly with head form, thread and finish; use this figure for freight estimation only.
Installation Tips for M0.6 Micro Miniature Small Pan-Head Phillips Machine Screws
- Pozidriv (PZ) drivers ride out of Phillips (PH) recesses and vice versa — confirm the recess marking on the head before assembly.
- For automated assembly, an ACR (Anti-Cam-Out Ribs) or torx-equivalent driver gives noticeably longer bit life than plain PH.
- At M0.6 the joint is sensitive to over-torque — use a torque-limiting driver and check the head doesn't bury into a softer counterpart.
Mating Parts for M0.6
For M0.6, pair with a M0.6 hex nut (ISO 4032 / DIN 934) and, where used, a M0.6 flat washer (ISO 7089 / DIN 125A) under the head and under the nut.
Custom manufacturing · Made to drawing
Need micro miniature small pan-head phillips machine screws in a size this table does not list?
This page covers M0.6 micro miniature small pan-head phillips machine screws. Where the standard stops, the drawing takes over: fine pitches, left-hand threads, partial threading, and property classes above the catalogued grade where material and heat treatment allow. Made by cold heading or warm forging.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
