M10 Wing Screws (DIN 316 Form) dimensions to DIN 316: coarse thread pitch 1.5 mm, clearance hole (ISO 273 medium) 11 mm, tapping drill 8.5 mm.
- Coarse thread pitch
- 1.5 mm
- Clearance hole (ISO 273 medium)
- 11 mm
- Tapping drill
- 8.5 mm
Figures are nominal values from the governing standard. Confirm against the tolerance class for your application before machining or ordering.
Dimensional data for M10 Wing Screws (DIN 316 Form) to DIN 316, with the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M10 Dimensional Row (DIN 316)
| Thread size | Pitch (mm) | Wing span A (mm) | Wing height (mm) | Boss diameter (mm) | Common length range (mm) | Material | Reference standard |
|---|
| M10 | 1.5 | 48 | 21 | 20 | 16~60 | Steel zinc | DIN 316 |
Hole Sizes for M10
| Coarse-thread pitch (ISO 724) | 1.5 mm |
|---|
| Through-hole / clearance (ISO 273 medium) | 11 mm |
|---|
| Tapping drill, coarse thread | 8.5 mm |
|---|
Mating Parts for M10
For M10, pair with a M10 hex nut (ISO 4032 / DIN 934) and, where used, a M10 flat washer (ISO 7089 / DIN 125A) under the head and under the nut.
Custom manufacturing · Made to drawing
Need wing screws (din 316 form) in a size this table does not list?
This page covers M10 wing screws (din 316 form). A non-standard screw is quoted from the drawing; where one already exists in the catalog, the special is usually a variation on its tooling. Made by cold heading or warm forging.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
Custom screw manufacturingSend a drawing
Applications & Industries for M10 Wing Screws
The sectors that buy Wing Screws to DIN 316, and the duty each one buys them for. Stocked from M4 to M10.
Industries that specify Wing Screws
-
Guards & covers
Panels removed for cleaning and inspection.
-
Exhibition & staging
Structures built and struck without tools.
-
Machine guarding
Covers and guards opened by an operator without a tool.
-
Jigs & fixtures
Setups changed several times a shift.
-
Laboratory & test equipment
Panels and clamps adjusted by hand during a run.
Typical applications
- frequent opening by hand
- tool-free clamping with more leverage than a knurled head
- adjustment that has to be made by hand while the machine runs
- tool-free opening and closing of a panel or clamp
Service conditions to specify against
- Marine and coastal
- Available in A4 (316) stainless for chloride exposure — coastal structures, pool halls, water treatment and deck hardware, where A2 will eventually pit.
Where to use something else
- Not for a joint that needs a defined clamp load; a hand-tightened screw carries only what a hand can produce.
Full application guide: where Wing Screws are used, how to specify them, and the cases they are wrong for