This page covers M16 Stud / Threaded Rod to ISO / DIN: the full dimensional row, hole and tool sizes, proof-load data and typical applications. All values are taken from the governing standards (ISO / DIN together with ISO 273, ISO 724 and ISO 898-1 where applicable).
M16 Dimensional Row (ISO / DIN)
| Thread size | Pitch (mm) | Length L (mm) | Engagement depth bm (mm) | Material | Reference standard |
|---|---|---|---|---|---|
| M16 | 2.0 | 150 | 24 | Cl. 8.8 alloy steel | DIN 939 / GB/T 901 |
Spanner & Drive for M16 Stud / Threaded Rod — ISO / DIN (Series 154)
Drive geometry for M16 Stud / Threaded Rod — ISO / DIN (Series 154) is given by the row above; match the tool to the listed values.
Hole Sizes for M16
| Coarse-thread pitch (ISO 724) | 2 mm |
|---|---|
| Through-hole / clearance (ISO 273 medium) | 17.5 mm |
| Tapping drill, coarse thread | 14 mm |
Tightening Torque for M16
| Class 8.8 (dry, ~µ 0.125) | ≈ 210 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 295 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 355 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M16
| Tensile stress area As (ISO 898-1) | 157 mm² |
|---|---|
| Proof load, class 8.8 | 91 kN |
| Proof load, class 10.9 | 130 kN |
| Proof load, class 12.9 | 152 kN |
| Min. ultimate tensile, class 8.8 | 126 kN |
Proof load = stress area × proof stress per ISO 898-1. Design joints so the working preload stays below the proof load of the selected class.
M16 Stud / Threaded Rod — ISO / DIN (Series 154) Weight
A steel M16 stud / threaded rod at the listed 150 mm length weighs approximately 237 g each — about 237 kg per 1,000 pieces. Stainless A2/A4 weighs roughly the same (density 7.9–8.0 g/cm³). Actual weight varies slightly with head form, thread and finish; use this figure for freight estimation only.
Common Applications for M16 Stud / Threaded Rod — ISO / DIN (Series 154)
M16 Stud / Threaded Rod — ISO / DIN (Series 154) are commonly specified for medium-duty structural connections, automotive sub-frames and equipment chassis.
Mating Parts for M16
For M16, pair with a M16 hex nut (ISO 4032 / DIN 934) and, where used, a M16 flat washer (ISO 7089 / DIN 125A) under the head and under the nut.
When to Step Up or Down from M16
When the joint preload approaches the proof load of M16 class 8.8, step up to M20 class 8.8 (or move to M16 class 10.9). When the joint is over-specified, M12 often saves weight and cost without losing the safety margin.