The M18 size of Thin Hex Nut, Fine Pitch is dimensioned by GB/T 6173 / ISO 8675. The table below gives the dimensional row from the standard, followed by the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M18 Dimensional Row (GB/T 6173 / ISO 8675)
| Size | Pitch (mm) | Width across flats s (mm) | Width across corners e (mm) | Nut height m (mm) | Reference standard |
|---|---|---|---|---|---|
| M18 | 2.5 | 27.0 | 30.14 | 9.0 | ISO 4035 / GB/T 6172 |
Spanner & Drive for M18 Thin Hex Nut, Fine Pitch — GB/T 6173 / ISO 8675 (Series 056)
M18 Thin Hex Nut, Fine Pitch — GB/T 6173 / ISO 8675 (Series 056) have a width across flats of 27.0 mm — fit a 27.0 mm open-ended spanner or socket. In tight access a 6-point socket on the 27.0 mm flats gives the most engagement per degree of swing. Where the joint is torqued to a figure, a click wrench is the only way to reproduce it across a batch.
Tightening Torque for M18
| Class 8.8 (dry, ~µ 0.125) | ≈ 297 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 423 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 495 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M18
Nuts are graded to ISO 898-2 by the proof load the nut itself will hold (classes 04, 05, 5, 6, 8, 10 and 12), not by the 8.8 / 10.9 / 12.9 scale used for bolts. A class-8 nut is the correct mate for a class-8.8 bolt, and the joint is designed on the bolt, so no bolt-tension figure is quoted here.
Installation Tips for M18 Thin Hex Nut, Fine Pitch — GB/T 6173 / ISO 8675 (Series 056)
- Use a 6-point socket where access allows — 12-point sockets are more prone to rounding the corners on smaller sizes.
- Serrated flanges need to sit directly on the joint face. A washer between the two removes the bite and leaves an ordinary bolted joint that is believed to be a locking one.
- At M18 the stretch in the bolt becomes the controlling factor — for critical joints, use angle-controlled or stretch-controlled tightening instead of pure torque.
Mating Parts for M18
Pair M18 with the matching M18 bolt or screw, plus a M18 flat washer where required to distribute load on softer materials.
Custom manufacturing · Made to drawing
Need thin hex nut, fine pitch in a size this table does not list?
This page covers M18 thin hex nut, fine pitch. Thread size is the obvious variable and rarely the interesting one — height for clearance, across-flats for the tool already in the cell, and the locking feature for the vibration actually present. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
