Dimensional data for M18 Hex Nut to GB/T 6170 / ISO 4032, with the drive and the installation notes for this type. Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M18 Dimensional Row (GB/T 6170 / ISO 4032)
| Size | Pitch (mm) | Width across flats s (mm) | Width across corners e (mm) | Nut height m (mm) | Reference standard |
|---|---|---|---|---|---|
| M18 | 2.5 | 27.0 | 30.14 | 15.8 | ISO 4032 / GB/T 6170 |
Spanner & Drive for M18 Hex Nut — GB/T 6170 / ISO 4032 (Series 066)
M18 Hex Nut — GB/T 6170 / ISO 4032 (Series 066) have a width across flats of 27.0 mm — fit a 27.0 mm open-ended spanner or socket. Use a 6-point socket for tight clearances and to reduce rounding; for repeated assembly choose a torque wrench so the joint preload is repeatable.
Tightening Torque for M18
| Class 8.8 (dry, ~µ 0.125) | ≈ 290 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 405 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 485 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M18
| Tensile stress area As (ISO 898-1) | 192 mm² |
|---|---|
| Proof load, class 8.8 | 115 kN |
| Proof load, class 10.9 | 159 kN |
| Proof load, class 12.9 | 186 kN |
| Min. ultimate tensile, class 8.8 | 154 kN |
Proof load = stress area × proof stress per ISO 898-1. Design joints so the working preload stays below the proof load of the selected class.
Common Applications for M18 Hex Nut — GB/T 6170 / ISO 4032 (Series 066)
M18 Hex Nut — GB/T 6170 / ISO 4032 (Series 066) are commonly specified for structural joints, flange connections and heavy equipment foundations.
Installation Tips for M18 Hex Nut — GB/T 6170 / ISO 4032 (Series 066)
- Use a 6-point socket where access allows — 12-point sockets are more prone to rounding the corners on smaller sizes.
- On flanged or serrated variants, do NOT add a separate flat washer — the flange already spreads the load and the washer can defeat the locking serrations.
- At M18 the stretch in the bolt becomes the controlling factor — for critical joints, use angle-controlled or stretch-controlled tightening instead of pure torque.
Mating Parts for M18
Pair M18 with the matching M18 bolt or screw, plus a M18 flat washer where required to distribute load on softer materials.
