M24 Chemical Anchor Studs (Resin-Bonded) Dimensions

Applications & Industries for M24 Chemical Anchor Studs

The sectors that buy Chemical Anchor Studs, and the duty each one buys them for. Stocked from M8 to M24.

Industries that specify Chemical Anchor Studs

• Close-to-edge fixings Anchors near a slab edge or at tight spacing.
• Rebar & retrofit connections Starter bars and post-installed reinforcement.
• Hollow block & masonry Resin with a sleeve where expansion would break the block.
• Building services Suspending tray, duct, pipe and sprinkler runs from a soffit.
• Plant installation Machines and equipment held down to a concrete floor.
• Fit-out & drylining Fixings into board, block and hollow wall.

Typical applications

• bonded fixings with no expansion force in the substrate
• hole cleaning is most of the installation quality
• cure time roughly halves for every 10 °C above 20 °C
• making a load-bearing threaded fixing in concrete or masonry
• fixing a steel fixture through to a solid substrate
• suspended services on threaded rod

Service conditions to specify against

Marine and coastal

Available in A4 (316) stainless for chloride exposure — coastal structures, pool halls, water treatment and deck hardware, where A2 will eventually pit.

Sealed joints

Used where the fixing has to keep water or air out as well as hold — the elastomer, not the fastener, decides service life.

Hole preparation

Drilled diameter, depth and cleanliness are part of the specification; an uncleaned hole is the single most common cause of a failed anchor.

The concrete governs

Capacity is a property of the base material and the geometry — grade, edge distance, spacing and cracked or uncracked — not of the anchor alone. Work to the anchor manufacturer's ETA or ICC-ES report.

Where to use something else

• Not for a substrate the type is not qualified in — an expansion anchor near an edge or in hollow block will split it.

Need help matching Chemical Anchor Studs to your application? Send the assembly, the load and the environment with your enquiry and we will specify the size, material and finish against them.