M24 Thin Castle Nuts (DIN 937) are manufactured to DIN 937. This page lists the controlling dimensions for the M24 size together with the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M24 Dimensional Row (DIN 937)
| Thread size | Pitch (mm) | Width across flats s (mm) | Total height m (mm) | Height vs DIN 935 | Slot width n (mm) | Split pin size | Reference standard |
|---|---|---|---|---|---|---|---|
| M24 | 3.0 | 36.0 | 19.0 | approx. 79% | 5.5 | 5 x 63 | DIN 937 |
Spanner & Drive for M24 Thin Castle Nuts (DIN 937)
Drive geometry for M24 Thin Castle Nuts (DIN 937) is given by the row above; match the tool to the listed values.
Tightening Torque for M24
| Class 8.8 (dry, ~µ 0.125) | ≈ 726 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 1034 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 1210 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M24
Nuts are graded to ISO 898-2 by the proof load the nut itself will hold (classes 04, 05, 5, 6, 8, 10 and 12), not by the 8.8 / 10.9 / 12.9 scale used for bolts. A class-8 nut is the correct mate for a class-8.8 bolt, and the joint is designed on the bolt, so no bolt-tension figure is quoted here.
Installation Tips for M24 Thin Castle Nuts (DIN 937)
- At M24 the stretch in the bolt becomes the controlling factor — for critical joints, use angle-controlled or stretch-controlled tightening instead of pure torque.
Mating Parts for M24
Pair M24 with the matching M24 bolt or screw, plus a M24 flat washer where required to distribute load on softer materials.
Custom manufacturing · Made to drawing
Need thin castle nuts (din 937) in a size this table does not list?
This page covers M24 thin castle nuts (din 937). Height and across-flats are the two most often changed — a thinner nut for clearance, a larger hex for a tool that is already on the line. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
