The M5 size of Sealing Cap Nuts is dimensioned by DIN 1587. The table below gives the dimensional row from the standard, followed by the drive and the installation notes for this type.
M5 Dimensional Row (DIN 1587)
| Thread size | Pitch (mm) | Across flats s (mm) | Across corners e (mm) | Total height m (mm) | Dome diameter (mm) | O-ring seat | Reference standard |
|---|---|---|---|---|---|---|---|
| M5 | 0.8 | 8 | 8.79 | 10 | 8 | 4.5 x 1.5 NBR | DIN 1587 + O-ring |
Spanner & Drive for M5 Sealing Cap Nuts
Drive geometry for M5 Sealing Cap Nuts is given by the row above; match the tool to the listed values.
Tightening Torque for M5
| Class 8.8 (dry, ~µ 0.125) | ≈ 5.8 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 8.1 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 9.7 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M5
| Tensile stress area As (ISO 898-1) | 14.2 mm² |
|---|---|
| Proof load, class 8.8 | 8.2 kN |
| Proof load, class 10.9 | 11.8 kN |
| Proof load, class 12.9 | 13.8 kN |
| Min. ultimate tensile, class 8.8 | 11.4 kN |
Proof load = stress area × proof stress per ISO 898-1. Design joints so the working preload stays below the proof load of the selected class.
Common Applications for M5 Sealing Cap Nuts
M5 Sealing Cap Nuts are commonly specified for paired with the same-size screws on PCB hardware, light enclosures and small-scale assemblies.
Installation Tips for M5 Sealing Cap Nuts
- At M5 the joint is sensitive to over-torque — use a torque-limiting driver and check the head doesn't bury into a softer counterpart.
When to Step Up or Down from M5
When the joint preload approaches the proof load of M5 class 8.8, step up to M6 class 8.8 (or move to M5 class 10.9). When the joint is over-specified, M4 often saves weight and cost without losing the safety margin.
