Dimensional data for M5 T-Slot Nuts to DIN 508, with the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M5 Dimensional Row (DIN 508)
| Thread size | T-slot width (mm) | Nut width b (mm) | Total height h (mm) | Key height h1 (mm) | Hook width e (mm) | Reference standard |
|---|---|---|---|---|---|---|
| M5 | 6 | 8.0 | 8.0 | 4.5 | 6.4 | DIN 508 / GN505 |
Spanner & Drive for M5 T-Slot Nuts
Drive geometry for M5 T-Slot Nuts is given by the row above; match the tool to the listed values.
Tightening Torque for M5
| Class 8.8 (dry, ~µ 0.125) | ≈ 5.9 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 8.7 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 10 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M5
Nuts are graded to ISO 898-2 by the proof load the nut itself will hold (classes 04, 05, 5, 6, 8, 10 and 12), not by the 8.8 / 10.9 / 12.9 scale used for bolts. A class-8 nut is the correct mate for a class-8.8 bolt, and the joint is designed on the bolt, so no bolt-tension figure is quoted here.
Installation Tips for M5 T-Slot Nuts
- At M5 the joint is sensitive to over-torque — use a torque-limiting driver and check the head doesn't bury into a softer counterpart.
Mating Parts for M5
Pair M5 with the matching M5 bolt or screw, plus a M5 flat washer where required to distribute load on softer materials.
Custom manufacturing · Made to drawing
Need t-slot nuts in a size this table does not list?
This page covers M5 t-slot nuts. Thread size is the obvious variable and rarely the interesting one — height for clearance, across-flats for the tool already in the cell, and the locking feature for the vibration actually present. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
