Specification summary of ASME B30.26 as applied to screw-pin anchor shackles: the dimensions the standard fixes, the full size range supplied, and the related designations commonly cross-referenced.
ASME B30.26 — Scope
The table below lists the dimensions catalogued for screw-pin anchor shackles under ASME B30.26. The scope of ASME B30.26 itself is not summarised here — where a figure matters, confirm it against the published document.
Tolerance & Product Grades
Product grade is a concept from dimensional fastener standards and does not apply to ASME B30.26. Tolerances for this part are the limits shown against each dimension in the table.
Dimensions Specified by ASME B30.26
| Body | Pin type | Suitable for | Not suitable for |
|---|---|---|---|
| anchor (bow) | screw pin | frequent connection and disconnection | long-term or unattended installation |
| anchor (bow), galvanised | screw pin | frequent connection and disconnection | loads that can rotate the pin |
| anchor (bow) | bolt, nut and split pin | long-term and unattended installation |
Equivalent Standards
Where direct equivalents exist (ISO ↔ DIN, ISO ↔ ASME), they are listed on the parent Screw-Pin Anchor Shackles page.
Always confirm against the dimensions on this page, since some "equivalent" standards differ in tolerances and head geometry.
Companion Standards
A complete specification for screw-pin anchor shackles normally cites several documents: one for the geometry, one for the material or mechanical properties, and one for the finish. ASME B30.26 is one of them, not all of them.
Custom manufacturing · Made to drawing
Need a rigging hardware to this standard in a non-standard size?
Parts built to ASME B30 26 are already in the catalog, so a special is usually a variation on existing tooling rather than a new design — which is what keeps the cost down. Made by hot forging.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.







