T-Slot Nuts manufactured to DIN 508 follow a specific scope. This page summarizes that scope, lists every dimension the standard fixes, and points to the most common cross-references.
DIN 508 — Scope
DIN 508 specifies the dimensions and tolerances of t-slot nuts. Material, property class, surface finish and packaging are governed by separate documents in the same standards family (for example ISO 898-1 for the mechanical property classes of bolts and screws).
Tolerance & Product Grades
DIN 508, alongside the related DIN 508 entries on this site, specifies product grades (typically A or B for fine work and C for general engineering) and tolerance classes for the controlling dimensions. Choose the grade against the precision your application requires.
Dimensions Specified by DIN 508
| Thread size | T-slot width (mm) | Nut width b (mm) | Total height h (mm) | Key height h1 (mm) | Hook width e (mm) | Reference standard |
|---|---|---|---|---|---|---|
| M5 | 6 | 8.0 | 8.0 | 4.5 | 6.4 | DIN 508 / GN505 |
| M6 | 8 | 10.0 | 10.0 | 5.5 | 8.4 | DIN 508 / GN505 |
| M8 | 10 | 12.0 | 12.0 | 7.0 | 10.4 | DIN 508 / GN505 |
| M8 | 12 | 14.0 | 12.0 | 7.0 | 12.4 | DIN 508 / GN505 |
| M10 | 12 | 14.0 | 14.0 | 8.0 | 12.4 | DIN 508 / GN505 |
| M10 | 14 | 16.0 | 14.0 | 8.0 | 14.4 | DIN 508 / GN505 |
| M12 | 14 | 16.0 | 17.0 | 10.0 | 14.4 | DIN 508 / GN505 |
| M12 | 18 | 20.0 | 17.0 | 10.0 | 18.4 | DIN 508 / GN505 |
| M16 | 18 | 20.0 | 20.0 | 12.0 | 18.4 | DIN 508 / GN505 |
| M16 | 22 | 25.0 | 20.0 | 12.0 | 22.4 | DIN 508 / GN505 |
| M20 | 22 | 25.0 | 25.0 | 15.0 | 22.4 | DIN 508 / GN505 |
| M20 | 28 | 32.0 | 25.0 | 15.0 | 28.4 | DIN 508 / GN505 |
| M24 | 28 | 32.0 | 30.0 | 18.0 | 28.4 | DIN 508 / GN505 |
Equivalent Standards
Where direct equivalents exist (ISO ↔ DIN, ISO ↔ ASME), they are listed on the parent T-Slot Nuts page. Always confirm against the dimensions on this page, since some "equivalent" standards differ in tolerances and head geometry.
Companion Standards
DIN 508 controls only the geometry of t-slot nuts. The mechanical strength is set by ISO 898-1 (bolts and screws) or ISO 898-2 (nuts); the surface finish is governed by separate finish standards (e.g. ISO 4042 for electroplating). For corrosion testing, the relevant document is ISO 9227 (neutral salt spray).