For lag screws (hex wood screws), DIN 571 is the governing document for the dimensions listed below. Mechanical and performance requirements for this part family are set by its own standards, not by the bolt and screw property-class documents.
DIN 571 — Scope
DIN 571 specifies the dimensional requirements for lag screws (hex wood screws). Material, surface condition and any performance rating are set by separate documents specific to this part family — ISO 898-1 and ISO 898-2, which govern bolt and nut property classes, do not apply here.
Tolerance & Product Grades
Tolerances for lag screws (hex wood screws) are given as limits on the individual dimensions in the table rather than as a fastener product grade. Where a general-tolerance class is cited on the drawing instead, it applies to the dimensions not otherwise toleranced.
Dimensions Specified by DIN 571
| Nominal diameter (mm) | Pitch (mm) | Width across flats s (mm) | Head height k (mm) | Pilot/guide hole (mm) | Common length range (mm) | Reference standard | Notes |
|---|---|---|---|---|---|---|---|
| 5 | 2.0 | 8.0 | 3.5 | 3.0 | 25~100 | DIN 571 | Wood screw, self-tapping point |
| 6 | 2.5 | 10.0 | 4.0 | 4.0 | 30~150 | DIN 571 | Wood screw, self-tapping point |
| 8 | 3.0 | 13.0 | 5.5 | 5.0 | 40~200 | DIN 571 | Wood screw, self-tapping point |
| 10 | 3.5 | 16.0 | 6.5 | 7.0 | 50~250 | DIN 571 | Wood screw, self-tapping point |
| 12 | 4.0 | 18.0 | 7.5 | 8.5 | 60~300 | DIN 571 | Wood screw, self-tapping point |
| 14 | 4.0 | 21.0 | 9.0 | 10.0 | 60~300 | DIN 571 | Wood screw, self-tapping point |
| 16 | 4.5 | 24.0 | 10.0 | 11.5 | 80~300 | DIN 571 | Wood screw, self-tapping point |
| 18 | 5.0 | 27.0 | 11.5 | 13.0 | 80~300 | DIN 571 | Wood screw, self-tapping point |
| 20 | 5.0 | 30.0 | 12.5 | 14.5 | 100~300 | DIN 571 | Wood screw, self-tapping point |
| 22 | 5.5 | 32.0 | 14.0 | 16.0 | 100~300 | DIN 571 | Wood screw, self-tapping point |
| 24 | 6.0 | 36.0 | 15.0 | 17.5 | 100~300 | DIN 571 | Wood screw, self-tapping point |
Equivalent Standards
Where direct equivalents exist (ISO ↔ DIN, ISO ↔ ASME), they are listed on the parent Lag Screws (Hex Wood Screws) page. Always confirm against the dimensions on this page, since some "equivalent" standards differ in tolerances and head geometry.
When to Specify DIN 571
DIN 571 is still widely used in European mechanical engineering and as a cross-reference on legacy drawings; its ISO equivalent is preferred for new designs.
