Serrated Flange Lock Nuts manufactured to DIN 6923 are dimensioned by the size table reproduced on this page. The standard fixes geometry and tolerances only; material and property class are assigned by separate documents, and surface finish by separate finish standards.
DIN 6923 — Scope
DIN 6923 is "Hexagon nuts with flange". Its ISO counterpart is ISO 4161.
Material, property class, surface finish and packaging are governed by separate documents — ISO 898-1 and ISO 898-2 for mechanical property classes, ISO 4042 for electroplated finishes.
Tolerance & Product Grades
DIN 6923 does not divide serrated flange lock nuts into product grades. Tolerances are given as limits on the individual dimensions in the table.
Where a general-tolerance class is cited on the drawing instead, it applies to the dimensions not otherwise toleranced.
Dimensions Specified by DIN 6923
| Thread size | Pitch (mm) | Across flats s (mm) | Flange diameter dc (mm) | Total height m (mm) | Flange thickness c (mm) | Reference standard |
|---|---|---|---|---|---|---|
| M4 | 0.7 | 7 | 9.0 | 5.0 | 1.0 | DIN 6923 |
| M5 | 0.8 | 8 | 11.8 | 5.0 | 1.0 | DIN 6923 |
| M6 | 1.0 | 10 | 14.2 | 6.0 | 1.1 | DIN 6923 |
| M8 | 1.25 | 13 | 17.9 | 8.0 | 1.2 | DIN 6923 |
| M10 | 1.5 | 15 | 21.8 | 10.0 | 1.5 | DIN 6923 |
| M12 | 1.75 | 18 | 26.0 | 12.0 | 1.8 | DIN 6923 |
| M14 | 2.0 | 21 | 29.9 | 14.0 | 2.1 | DIN 6923 |
| M16 | 2.0 | 24 | 34.5 | 16.0 | 2.4 | DIN 6923 |
| M20 | 2.5 | 30 | 42.8 | 20.0 | 3.0 | DIN 6923 |
Companion Standards
DIN 6923 controls only the geometry of serrated flange lock nuts. The mechanical strength is set by ISO 898-1 (bolts, screws and studs) or ISO 898-2 (nuts); the surface finish is governed by separate finish standards such as ISO 4042 for electroplating. For corrosion testing, the relevant document is ISO 9227 (neutral salt spray).
When to Specify DIN 6923
DIN 6923 is still widely used in European mechanical engineering and as a cross-reference on legacy drawings; its ISO equivalent is preferred for new designs.
Custom manufacturing · Made to drawing
Need a nut to this standard in a non-standard size?
Parts built to DIN 6923 are already in the catalog, so a special is usually a variation on existing tooling rather than a new design — which is what keeps the cost down. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
