DIN 7504 N is the standard cited for pan head self-drilling screws (din 7504 n). This page sets out what the standard controls for this part, reproduces the dimensional table supplied against it, and notes the related designations referenced on drawings.
DIN 7504 N — Scope
DIN 7504 N specifies the dimensional requirements for pan head self-drilling screws (din 7504 n).
Material, surface condition and any performance rating are set by separate documents specific to this part family — ISO 898-1 and ISO 898-2, which govern bolt and nut property classes, do not apply here.
Tolerance & Product Grades
Tolerances for pan head self-drilling screws (din 7504 n) are given as limits on the individual dimensions in the table rather than as a fastener product grade.
Where a general-tolerance class is cited on the drawing instead, it applies to the dimensions not otherwise toleranced.
Dimensions Specified by DIN 7504 N
| Head form | Point | Material and finish | Substrate | Pre-drilling |
|---|---|---|---|---|
| pan head | integrated drill tip | carbon steel, zinc plated | steel sheet and purlins | not required within the point capacity |
| pan head | integrated drill tip | carbon steel, zinc plated | metal roofing | not required within the point capacity |
| pan head | integrated drill tip | carbon steel, zinc plated | light steel structures | not required within the point capacity |
Companion Standards
DIN 7504 N controls only the geometry of pan head self-drilling screws (din 7504 n). Surface finish is governed by separate finish standards (for example ISO 4042 for electroplating), and corrosion testing by ISO 9227 (neutral salt spray). Mechanical performance is set by the standards specific to this part family, not by ISO 898-1 or ISO 898-2, which apply to bolts, screws and nuts.
When to Specify DIN 7504 N
DIN 7504 N is still widely used in European mechanical engineering and as a cross-reference on legacy drawings; its ISO equivalent is preferred for new designs.
