DIN is the governing dimensional standard for custom machined component. This page sets out the scope of the standard, reproduces the full size table it specifies, and lists the DIN/ISO/ASME cross-references commonly cited in datasheets and drawings.
DIN — Scope
DIN specifies the dimensions and tolerances of custom machined component — iso / din (series 115). Material, property class, surface finish and packaging are governed by separate documents in the same standards family (for example ISO 898-1 for the mechanical property classes of bolts and screws).
Tolerance & Product Grades
DIN, alongside the related ISO / DIN entries on this site, specifies product grades (typically A or B for fine work and C for general engineering) and tolerance classes for the controlling dimensions. Choose the grade against the precision your application requires.
Dimensions Specified by DIN
| Size designation | Outer diameter / width (mm) | Length / height (mm) | Bore / thread (mm) | Material | Reference standard |
|---|---|---|---|---|---|
| Size 1 | 10 | 20 | 6 | C45 carbon steel | GB/T 1804-m |
| Size 2 | 12 | 25 | 8 | C45 carbon steel | GB/T 1804-m |
| Size 3 | 16 | 32 | 10 | C45 carbon steel | GB/T 1804-m |
| Size 4 | 20 | 40 | 12 | C45 carbon steel | GB/T 1804-m |
| Size 5 | 25 | 50 | 16 | C45 carbon steel | GB/T 1804-m |
| Size 6 | 32 | 63 | 20 | C45 carbon steel | GB/T 1804-m |
| Size 7 | 40 | 80 | 25 | C45 carbon steel | GB/T 1804-m |
| Size 8 | 50 | 100 | 30 | C45 carbon steel | GB/T 1804-m |
Companion Standards
DIN controls only the geometry of custom machined component — iso / din (series 115). The mechanical strength is set by ISO 898-1 (bolts and screws) or ISO 898-2 (nuts); the surface finish is governed by separate finish standards (e.g. ISO 4042 for electroplating). For corrosion testing, the relevant document is ISO 9227 (neutral salt spray).
When to Specify DIN
DIN is still widely used in European mechanical engineering and as a cross-reference on legacy drawings; its ISO equivalent is preferred for new designs.