Spring Lock Washer — GB/T 5782 / ISO 4014 (Series 003) manufactured to ISO 4014 follow a specific scope. This page summarizes that scope, lists every dimension the standard fixes, and points to the most common cross-references.
ISO 4014 — Scope
ISO 4014 specifies the dimensions and tolerances of spring lock washer — gb/t 5782 / iso 4014 (series 003). Material, property class, surface finish and packaging are governed by separate documents in the same standards family (for example ISO 898-1 for the mechanical property classes of bolts and screws).
Tolerance & Product Grades
ISO 4014, alongside the related GB/T 5782 / ISO 4014 entries on this site, specifies product grades (typically A or B for fine work and C for general engineering) and tolerance classes for the controlling dimensions. Choose the grade against the precision your application requires.
Dimensions Specified by ISO 4014
| For bolt size | Inner diameter d1 (mm) | Outer diameter d2 (mm) | Width b (mm) | Thickness t (mm) | Reference standard |
|---|---|---|---|---|---|
| M3 | 3.1 | 6.2 | 1.0 | 0.8 | GB/T 93 / DIN 127B |
| M4 | 4.1 | 7.6 | 1.2 | 1.0 | GB/T 93 / DIN 127B |
| M5 | 5.1 | 9.2 | 1.5 | 1.2 | GB/T 93 / DIN 127B |
| M6 | 6.1 | 11.8 | 2.0 | 1.6 | GB/T 93 / DIN 127B |
| M8 | 8.1 | 14.8 | 2.5 | 2.0 | GB/T 93 / DIN 127B |
| M10 | 10.2 | 18.1 | 3.0 | 2.5 | GB/T 93 / DIN 127B |
| M12 | 12.2 | 21.1 | 3.5 | 3.0 | GB/T 93 / DIN 127B |
| M14 | 14.2 | 24.1 | 4.0 | 3.5 | GB/T 93 / DIN 127B |
| M16 | 16.2 | 27.4 | 4.5 | 4.0 | GB/T 93 / DIN 127B |
| M18 | 18.2 | 29.4 | 5.0 | 4.5 | GB/T 93 / DIN 127B |
| M20 | 20.2 | 33.6 | 5.5 | 5.0 | GB/T 93 / DIN 127B |
| M24 | 24.5 | 40.1 | 6.5 | 6.0 | GB/T 93 / DIN 127B |
| M30 | 30.5 | 50.0 | 8.0 | 7.5 | GB/T 93 / DIN 127B |
Equivalent Standards
ISO 4014 (partial thread) corresponds closely to DIN 931; the fully-threaded variant ISO 4017 corresponds to DIN 933.
Companion Standards
ISO 4014 controls only the geometry of spring lock washer — gb/t 5782 / iso 4014 (series 003). The mechanical strength is set by ISO 898-1 (bolts and screws) or ISO 898-2 (nuts); the surface finish is governed by separate finish standards (e.g. ISO 4042 for electroplating). For corrosion testing, the relevant document is ISO 9227 (neutral salt spray).