Specification summary of ISO 7089 as applied to gl-xlc rotating shaft: the dimensions the standard fixes, the full size range supplied, and the related designations commonly cross-referenced.
ISO 7089 — Scope
ISO 7089 is "Plain washers — Normal series — Product grade A".
Tolerance & Product Grades
ISO 7089 is written to product grade A; a different grade of the same part is a different document in the family, not a variant of this one.
Dimensions Specified by ISO 7089
| Size designation | Outer diameter / width (mm) | Length / height (mm) | Bore / thread (mm) | Material | Reference standard |
|---|---|---|---|---|---|
| Size 1 | 10 | 20 | 6 | C45 carbon steel | GB/T 1804-m |
| Size 2 | 12 | 25 | 8 | C45 carbon steel | GB/T 1804-m |
| Size 3 | 16 | 32 | 10 | C45 carbon steel | GB/T 1804-m |
| Size 4 | 20 | 40 | 12 | C45 carbon steel | GB/T 1804-m |
| Size 5 | 25 | 50 | 16 | C45 carbon steel | GB/T 1804-m |
| Size 6 | 32 | 63 | 20 | C45 carbon steel | GB/T 1804-m |
| Size 7 | 40 | 80 | 25 | C45 carbon steel | GB/T 1804-m |
| Size 8 | 50 | 100 | 30 | C45 carbon steel | GB/T 1804-m |
Equivalent Standards
ISO 7089 flat washers correspond to DIN 125A.
Companion Standards
ISO 7089 controls the geometry of gl-xlc rotating shaft — gb/t 97.1 / iso 7089 (series 085). Surface finish is governed by separate finish standards such as ISO 4042 for electroplating, and corrosion testing by ISO 9227 (neutral salt spray). Mechanical performance is set by the documents specific to this part family — ISO 898-1 and ISO 898-2 apply to bolts, screws, studs and nuts, and not here.
Custom manufacturing · Made to drawing
Need a machined component to this standard in a non-standard size?
Parts built to ISO 7089 are already in the catalog, so a special is usually a variation on existing tooling rather than a new design — which is what keeps the cost down. Made by warm forging or thread turning.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
