Angular Contact Ball Bearing — ISO / DIN (Series 137) manufactured to ISO follow a specific scope. This page summarizes that scope, lists every dimension the standard fixes, and points to the most common cross-references.
ISO — Scope
ISO specifies the dimensions and tolerances of angular contact ball bearing — iso / din (series 137). Material, property class, surface finish and packaging are governed by separate documents in the same standards family (for example ISO 898-1 for the mechanical property classes of bolts and screws).
Tolerance & Product Grades
ISO, alongside the related ISO / DIN entries on this site, specifies product grades (typically A or B for fine work and C for general engineering) and tolerance classes for the controlling dimensions. Choose the grade against the precision your application requires.
Dimensions Specified by ISO
| Bore d (mm) | Outer diameter D (mm) | Width B (mm) | Contact angle (deg) | Dynamic load C (kN) | Reference standard |
|---|---|---|---|---|---|
| 10 | 30 | 9 | 15 | 5.85 | ISO 76 / GB/T 292 |
| 15 | 35 | 11 | 15 | 8.06 | ISO 76 / GB/T 292 |
| 20 | 47 | 14 | 15 | 12.5 | ISO 76 / GB/T 292 |
| 25 | 52 | 15 | 15 | 14.8 | ISO 76 / GB/T 292 |
| 30 | 62 | 16 | 15 | 20.3 | ISO 76 / GB/T 292 |
| 40 | 80 | 18 | 15 | 32.5 | ISO 76 / GB/T 292 |
| 50 | 90 | 20 | 15 | 37.5 | ISO 76 / GB/T 292 |
| 60 | 110 | 22 | 25 | 55.0 | ISO 76 / GB/T 292 |
| 70 | 125 | 24 | 25 | 70.2 | ISO 76 / GB/T 292 |
| 80 | 140 | 26 | 25 | 82.4 | ISO 76 / GB/T 292 |
Equivalent Standards
Where direct equivalents exist (ISO ↔ DIN, ISO ↔ ASME), they are listed on the parent Angular Contact Ball Bearing — ISO / DIN (Series 137) page. Always confirm against the dimensions on this page, since some "equivalent" standards differ in tolerances and head geometry.
Companion Standards
ISO controls only the geometry of angular contact ball bearing — iso / din (series 137). The mechanical strength is set by ISO 898-1 (bolts and screws) or ISO 898-2 (nuts); the surface finish is governed by separate finish standards (e.g. ISO 4042 for electroplating). For corrosion testing, the relevant document is ISO 9227 (neutral salt spray).