ISO covers the dimensional requirements for o-ring seal. Reproduced below: the complete size table, the tolerance grades, and the companion and equivalent standards referenced when ordering to this document.
ISO — Scope
ISO specifies the dimensions and tolerances of o-ring seal — iso / din (series 159). Material, property class, surface finish and packaging are governed by separate documents in the same standards family (for example ISO 898-1 for the mechanical property classes of bolts and screws).
Tolerance & Product Grades
ISO, alongside the related ISO / DIN entries on this site, specifies product grades (typically A or B for fine work and C for general engineering) and tolerance classes for the controlling dimensions. Choose the grade against the precision your application requires.
Dimensions Specified by ISO
| Inner diameter d1 (mm) | Outer diameter d2 (mm) | Wire dia (mm) | Material | Working temp range | Reference standard |
|---|---|---|---|---|---|
| 5 | 9 | 2 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 8 | 12 | 2 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 10 | 16 | 3 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 15 | 21 | 3 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 20 | 26 | 3 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 25 | 33 | 4 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 30 | 38 | 4 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 40 | 50 | 5 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 50 | 60 | 5 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 60 | 72 | 6 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 80 | 92 | 6 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
| 100 | 114 | 7 | NBR 70 | -30 to +110 C | ISO 3601 / GB/T 3452 |
Equivalent Standards
Where direct equivalents exist (ISO ↔ DIN, ISO ↔ ASME), they are listed on the parent O-Ring Seal — ISO / DIN (Series 159) page. Always confirm against the dimensions on this page, since some "equivalent" standards differ in tolerances and head geometry.
Companion Standards
ISO controls only the geometry of o-ring seal — iso / din (series 159). The mechanical strength is set by ISO 898-1 (bolts and screws) or ISO 898-2 (nuts); the surface finish is governed by separate finish standards (e.g. ISO 4042 for electroplating). For corrosion testing, the relevant document is ISO 9227 (neutral salt spray).