A2 Stainless Steel Drilled-Head Capstan Sealing Screws are supplied to GB/T 70.1 / DIN 912 / ISO 4762 and GB/T 70.3 / DIN 7991 / ISO 10642. The grade provides good general corrosion resistance and is largely non-magnetic; the practical service range is approx. -200 °C to +400 °C, subject to the property class and the joint. Property data, grade comparison and the full size table follow.
Why Choose A2 Stainless Steel for Drilled-Head Capstan Sealing Screws
The most common stainless group for indoor and general outdoor fasteners. For drilled-head capstan sealing screws, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Good general corrosion resistance |
Corrosion Behavior in Service
A2 (304) gives excellent atmospheric and most-water corrosion resistance and is the most common stainless for Drilled-Head Capstan Sealing Screws in indoor and general outdoor service. In chloride-bearing environments (marine air, road salt, swimming pools) consider stepping up to A4 (316).
Galvanic & Galling Considerations
Two important notes for stainless drilled-head capstan sealing screws: (1) stainless can gall on stainless threads under load — use a thread lubricant or anti-galling compound, especially for M6 and below; (2) when joined to aluminum or galvanized steel, stainless can drive galvanic corrosion of the less-noble metal in wet service — isolate with a coating or sleeve where appropriate.
Using Stainless Fasteners in Aluminum
The galvanic couple here runs the wrong way: aluminum is the less noble metal, so it corrodes and the fastener does not. What governs the rate is the ratio of areas — a large anode and a small cathode is a tolerable combination, the reverse concentrates the attack into thin material around the hole. An isolating washer plus sealant breaks the circuit; where that is impractical, match the fastener to the substrate.
Sizes of Drilled-Head Capstan Sealing Screws Available in A2 Stainless Steel
| Head form | Governing standards | Sealing feature | Property class | Finish |
|---|---|---|---|---|
| hexagon socket head cap | GB/T 70.1-2008 / DIN 912 / ISO 4762 | cross-drilled head for sealing wire | 8.8 | black oxide |
| countersunk hexagon socket | GB/T 70.3-2008 / DIN 7991 / ISO 10642 | cross-drilled head for sealing wire | 8.8 | black oxide |
Dimensions are independent of the material: every size above is available in A2 Stainless Steel.
Custom manufacturing · Made to drawing
Need this screw in a grade that is not listed?
A2 Stainless Steel is one of the grades the catalog describes. Lengths and thread lengths outside the standard table are the commonest request, followed by a drive the standard does not offer and a head marked with your own part number. Made by cold heading or warm forging.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.







