A2 Stainless Steel (ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70) is the most common stainless group for indoor and general outdoor fasteners. Specified on male-to-female thread adapters it determines the corrosion behaviour (good general corrosion resistance) and the service temperature range (approx. -200 °C to +400 °C, subject to the property class and the joint); the dimensions are ours rather than a standard's, and are listed in full below.
Why Choose A2 Stainless Steel for Male-to-Female Thread Adapters
The most common stainless group for indoor and general outdoor fasteners. For male-to-female thread adapters, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Good general corrosion resistance |
Corrosion Behavior in Service
A2 (304) gives excellent atmospheric and most-water corrosion resistance and is the most common stainless for Male-to-Female Thread Adapters in indoor and general outdoor service. In chloride-bearing environments (marine air, road salt, swimming pools) consider stepping up to A4 (316).
Galvanic & Galling Considerations
Two important notes for stainless male-to-female thread adapters: (1) stainless can gall on stainless threads under load — use a thread lubricant or anti-galling compound, especially for M6 and below; (2) when joined to aluminum or galvanized steel, stainless can drive galvanic corrosion of the less-noble metal in wet service — isolate with a coating or sleeve where appropriate.
Using Stainless Fasteners in Aluminum
Expect the aluminum to corrode, not the fastener — stainless sits higher in the galvanic series, so the aluminum is the one that gives up material. A small fastener in a thick section spreads the loss over a large area and is usually fine; a large fastener in thin sheet concentrates it and is not. Keep water out of the joint, or isolate the two metals with a nylon or coated washer and a sealant.
Sizes of Male-to-Female Thread Adapters Available in A2 Stainless Steel
| Male thread example | Female thread example | Female length (in) | Hex length (in) | Across flats (in) | Male length (in) | Material options |
|---|---|---|---|---|---|---|
| M12×1.75 | 1/4-32 UNEF | 3/8 | 1-1/2 | 3/4 | 7/8 | 303 / A2 / A4 stainless; aluminum; black-oxide or zinc-plated steel |
| 1/2-28 UNEF | M6×0.75 | 303 / A2 / A4 stainless; aluminum; black-oxide or zinc-plated steel | ||||
| 6-32 through 1/2-13 | M4 through M12 | 3/8~1 | 1~2.5 | 3/16~1/2 | 303 / A2 / A4 stainless; aluminum; black-oxide or zinc-plated steel |
Dimensions are independent of the material: every size above is available in A2 Stainless Steel.
Custom manufacturing · Made to drawing
Need this bolt in a grade that is not listed?
A2 Stainless Steel is one of the grades the catalog describes. Where the standard stops, the drawing takes over: fine pitches, left-hand threads, partial threading, and property classes above the catalogued grade where material and heat treatment allow. Made by cold heading or hot forging.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.







