Material page for self-clinching standoffs for sheet metal in A2 Stainless Steel (ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70). The sizes below are the ones we supply; there is no published dimensional standard for this article, so the table rather than a standard number is what to quote. Corrosion behaviour is good general corrosion resistance and the service range is approx. -200 °C to +400 °C, subject to the property class and the joint.
Why Choose A2 Stainless Steel for Self-Clinching Standoffs for Sheet Metal
The most common stainless group for indoor and general outdoor fasteners. For self-clinching standoffs for sheet metal, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 3506 group A2 (304 / 1.4301), commonly supplied A2-70 |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C, subject to the property class and the joint |
| Corrosion characteristic | Good general corrosion resistance |
Corrosion Behavior in Service
A2 (304) gives excellent atmospheric and most-water corrosion resistance and is the most common stainless for Self-Clinching Standoffs for Sheet Metal in indoor and general outdoor service. In chloride-bearing environments (marine air, road salt, swimming pools) consider stepping up to A4 (316).
Comparable Grades
For Self-Clinching Standoffs for Sheet Metal, the alternative stainless grade is A4 (316). Choose A2 (304) for general use and A4 (316) wherever chlorides are present; the molybdenum in A4 is the whole difference. Remember that stainless is the corrosion answer, not the strength answer — for load, look at class 8.8 or 10.9 instead.
Using Stainless Fasteners in Aluminum
The galvanic couple here runs the wrong way: aluminum is the less noble metal, so it corrodes and the fastener does not. What governs the rate is the ratio of areas — a large anode and a small cathode is a tolerable combination, the reverse concentrates the attack into thin material around the hole. An isolating washer plus sealant breaks the circuit; where that is impractical, match the fastener to the substrate.
Sizes of Self-Clinching Standoffs for Sheet Metal Available in A2 Stainless Steel
| Thread size | Length options (mm) | Form options | Material options | Installation |
|---|---|---|---|---|
| M2.5 | 2 / 3 / 4 / 6 / 8 / 10 / 12 / 14 / 16 / 18 / 19 | through / partial / blind | steel / stainless / aluminum / hardened stainless | self-clinching in sheet metal |
| M3 | 2 / 3 / 4 / 6 / 8 / 10 / 12 / 14 / 16 / 18 / 19 | through / partial / blind | steel / stainless / aluminum / hardened stainless | self-clinching in sheet metal |
| M3.5 | 2 / 3 / 4 / 6 / 8 / 10 / 12 / 14 / 16 / 18 / 19 | through / partial / blind | steel / stainless / aluminum / hardened stainless | self-clinching in sheet metal |
Dimensions are independent of the material: every size above is available in A2 Stainless Steel.
Custom manufacturing · Made to drawing
Need this nut in a grade that is not listed?
A2 Stainless Steel is one of the grades the catalog describes. Locking method is specifiable independently of the rest: nylon insert, all-metal deformed thread, serrated flange, or none. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.







