A2 Stainless Steel Wing Nuts are stocked to DIN 315. The grade provides good general corrosion resistance and is largely non-magnetic; the practical service range is approx. -200 °C to +400 °C. Property data, grade comparison and the full size table follow.
Why Choose A2 Stainless Steel for Wing Nuts
The most common stainless grade for indoor and general outdoor fasteners. For wing nuts, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | A2-70 (304) |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C |
| Corrosion characteristic | Good general corrosion resistance |
Corrosion Behavior in Service
A2 (304) gives excellent atmospheric and most-water corrosion resistance and is the most common stainless for Wing Nuts in indoor and general outdoor service. In chloride-bearing environments (marine air, road salt, swimming pools) consider stepping up to A4 (316).
Galvanic & Galling Considerations
Two important notes for stainless wing nuts: (1) stainless can gall on stainless threads under load — use a thread lubricant or anti-galling compound, especially for M6 and below; (2) when joined to aluminum or galvanized steel, stainless can drive galvanic corrosion of the less-noble metal in wet service — isolate with a coating or sleeve where appropriate.
Sizes of Wing Nuts Available in A2 Stainless Steel
| Size | Pitch (mm) | Wing span (mm) | Wing height (mm) | Body height (mm) | Reference standard | Notes |
|---|---|---|---|---|---|---|
| M4 | 0.7 | 28 | 17 | 9 | DIN 315 | Hand-tightened wing nut |
| M5 | 0.8 | 32 | 19 | 10 | DIN 315 | Hand-tightened wing nut |
| M6 | 1.0 | 37 | 22 | 12 | DIN 315 | Hand-tightened wing nut |
| M8 | 1.25 | 45 | 27 | 15 | DIN 315 | Hand-tightened wing nut |
| M10 | 1.5 | 55 | 33 | 18 | DIN 315 | Hand-tightened wing nut |
| M12 | 1.75 | 64 | 38 | 22 | DIN 315 | Hand-tightened wing nut |