Property Class 12.9 Steel (ISO 898-1 property class 12.9) is the highest common strength class, for high-load machine assembly. Specified on soft-tip set screws (nylon and brass) it determines the corrosion behaviour (requires plating or black-oxide protection) and the service temperature range (commonly limited to approx. +300 °C; confirm against the coating and the load); the dimensions are ours rather than a standard's, and are listed in full below.
Why Choose Property Class 12.9 Steel for Soft-Tip Set Screws (Nylon and Brass)
The highest common strength class, for high-load machine assembly. For soft-tip set screws (nylon and brass), this matters when requires plating or black-oxide protection is the primary requirement.
Mechanical & Physical Properties
| Grade designation | ISO 898-1 property class 12.9 |
|---|---|
| Magnetic response | Magnetic |
| Service temperature | commonly limited to approx. +300 °C; confirm against the coating and the load |
| Corrosion characteristic | Requires plating or black-oxide protection |
Corrosion Behavior in Service
Carbon and alloy steel soft-tip set screws (nylon and brass) require a coating for corrosion protection. Zinc plating (with or without passivation) is the most common; hot-dip galvanizing is used for outdoor structural service; black-oxide is mainly a tarnish-prevention finish for tool-room use.
Galvanic & Galling Considerations
For soft-tip set screws (nylon and brass) in steel, the dominant compatibility issue is hydrogen embrittlement at high property classes (10.9 and above) when electroplated. Plating must be followed by an appropriate baking treatment, or a non-electroplated finish (mechanical zinc, zinc flake) should be substituted.
Sizes of Soft-Tip Set Screws (Nylon and Brass) Available in Property Class 12.9 Steel
| Thread size | Tip length (mm) | Holding force vs steel point | Max temperature (°C) | Drive | Common length range (mm) | Marks the shaft |
|---|---|---|---|---|---|---|
| M4 | 2.0 | approx. 40% | 100 | Hex socket | 6~20 | No |
| M5 | 2.5 | approx. 40% | 100 | Hex socket | 6~25 | No |
| M6 | 3.0 | approx. 40% | 100 | Hex socket | 8~30 | No |
| M6 | 3.0 | approx. 70% | 250 | Hex socket | 8~30 | No |
| M8 | 4.0 | approx. 70% | 250 | Hex socket | 10~40 | No |
| M10 | 5.0 | approx. 70% | 250 | Hex socket | 12~50 | No |
Dimensions are independent of the material: the table above lists the sizes supplied, and on this page every one of them is quoted in Property Class 12.9 Steel. The catalogue's default material column has been omitted here so it cannot be read as contradicting that.
Custom manufacturing · Made to drawing
Need this screw in a grade that is not listed?
Grade 12 9 Steel is one of the grades the catalog describes. Where the standard stops, the drawing takes over: fine pitches, left-hand threads, partial threading, and property classes above the catalogued grade where material and heat treatment allow. Made by cold heading or warm forging.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.








