Dimensional data for M18 Hex Nut to GB/T 41 / ISO 4034, with the drive and the installation notes for this type.
Values are taken from the governing standard rather than from a general machine-thread table, because this type is not selected on one.
M18 Dimensional Row (GB/T 41 / ISO 4034)
| Size | Pitch (mm) | Width across flats s (mm) | Width across corners e (mm) | Nut height m (mm) | Reference standard |
|---|---|---|---|---|---|
| M18 | 2.5 | 27.0 | 30.14 | 15.8 | ISO 4032 / GB/T 6170 |
Spanner & Drive for M18 Hex Nut — GB/T 41 / ISO 4034 (Series 060)
M18 Hex Nut — GB/T 41 / ISO 4034 (Series 060) have a width across flats of 27.0 mm — fit a 27.0 mm open-ended spanner or socket. A 6-point socket grips all six flats of the 27.0 mm hex and is what to reach for once a fastener has been on and off a few times; a 12-point ring spanner starts rounding a worn head. For repeatable preload, torque rather than feel.
Tightening Torque for M18
| Class 8.8 (dry, ~µ 0.125) | ≈ 297 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 423 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 495 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Proof Load & Strength for M18
Nuts are graded to ISO 898-2 by the proof load the nut itself will hold (classes 04, 05, 5, 6, 8, 10 and 12), not by the 8.8 / 10.9 / 12.9 scale used for bolts. A class-8 nut is the correct mate for a class-8.8 bolt, and the joint is designed on the bolt, so no bolt-tension figure is quoted here.
Installation Tips for M18 Hex Nut — GB/T 41 / ISO 4034 (Series 060)
- Use a 6-point socket where access allows — 12-point sockets are more prone to rounding the corners on smaller sizes.
- On flanged or serrated variants, do NOT add a separate flat washer — the flange already spreads the load and the washer can defeat the locking serrations.
- At M18 the stretch in the bolt becomes the controlling factor — for critical joints, use angle-controlled or stretch-controlled tightening instead of pure torque.
Mating Parts for M18
Pair M18 with the matching M18 bolt or screw, plus a M18 flat washer where required to distribute load on softer materials.
Custom manufacturing · Made to drawing
Need hex nut in a size this table does not list?
This page covers M18 hex nut. Height and across-flats are the two most often changed — a thinner nut for clearance, a larger hex for a tool that is already on the line. Made by cold heading or tapping.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
