Dimensional and assembly data for (M3.5) Slotted Headless Screws with Shank to ISO 2342. Includes head size and width across flats, clearance-hole and tapping-drill diameters, tightening torque per property class, and the sizes to step up or down to when the joint requires it.
(M3.5) Dimensional Row (ISO 2342)
| Size | Pitch P (mm) | b (mm) | d_s_min (mm) | d_s_max (mm) | n_nom (mm) | n_min (mm) | n_max (mm) | t_min (mm) | t_max (mm) | x_max (mm) | Length range l (mm) | Reference standard |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| (M3.5) | 0.6 | 4.2 | 3.32 | 3.5 | 0.5 | 0.56 | 0.7 | 1.5 | 1.78 | 1.5 | ISO 2342 |
Spanner & Drive for (M3.5) Slotted Headless Screws with Shank
The hex socket for (M3.5) Slotted Headless Screws with Shank is shown in the spec table — use the matching Allen / hex key (an ISO 2936 hex key set covers the full range). For a one-off, a T-handle key and a calibrated arm will do. For a batch, the only way to get the same preload twice is a torque-controlled driver.
Installation Tips for (M3.5) Slotted Headless Screws with Shank
- Use a quality Allen key fully seated in the socket — partial engagement is the most common cause of stripped sockets at this size.
- For countersunk and button-head variants, chamfer the through-hole to seat the head flush without preloading the head/shank fillet.
- At (M3.5) the joint is sensitive to over-torque — use a torque-limiting driver and check the head doesn't bury into a softer counterpart.
Mating Parts for (M3.5)
For (M3.5), pair with a (M3.5) hex nut (ISO 4032 / DIN 934) and, where used, a (M3.5) flat washer (ISO 7089 / DIN 125A) under the head and under the nut.
Custom manufacturing · Made to drawing
Need slotted headless screws with shank in a size this table does not list?
This page covers (M3.5) slotted headless screws with shank. Material and finish are usually what drives a special — a grade the standard part is not stocked in, or a coating chosen against a salt-spray figure instead of a default. Made by cold heading or warm forging.
Minimum order from 2,000 pieces; samples within 7 days of drawing approval.
