GB is the governing dimensional standard for wire rope. This page sets out the scope of the standard, reproduces the full size table it specifies, and lists the DIN/ISO/ASME cross-references commonly cited in datasheets and drawings.
GB — Scope
GB specifies the dimensions and tolerances of wire rope — gb/t 6170 / iso 4032 (series 063). Material, property class, surface finish and packaging are governed by separate documents in the same standards family (for example ISO 898-1 for the mechanical property classes of bolts and screws).
Tolerance & Product Grades
GB, alongside the related GB/T 6170 / ISO 4032 entries on this site, specifies product grades (typically A or B for fine work and C for general engineering) and tolerance classes for the controlling dimensions. Choose the grade against the precision your application requires.
Dimensions Specified by GB
| Nominal diameter (mm) | Construction | Min breaking force (kN) | Mass (kg/100m) | Material | Reference standard |
|---|---|---|---|---|---|
| 4 | 6x7 | 8.95 | 5.85 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 5 | 6x7 | 13.4 | 8.94 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 6 | 6x19 | 17.6 | 13.0 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 8 | 6x19 | 31.3 | 23.0 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 10 | 6x19 | 48.5 | 36.0 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 12 | 6x19 | 69.5 | 52.0 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 16 | 6x37 | 119 | 89.0 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 20 | 6x37 | 185 | 138.0 | Galvanized steel | GB/T 20118 / ISO 2408 |
| 24 | 6x37 | 265 | 196.0 | Galvanized steel | GB/T 20118 / ISO 2408 |
Equivalent Standards
Where direct equivalents exist (ISO ↔ DIN, ISO ↔ ASME), they are listed on the parent Wire Rope — GB/T 6170 / ISO 4032 (Series 063) page. Always confirm against the dimensions on this page, since some "equivalent" standards differ in tolerances and head geometry.
Companion Standards
GB controls only the geometry of wire rope — gb/t 6170 / iso 4032 (series 063). The mechanical strength is set by ISO 898-1 (bolts and screws) or ISO 898-2 (nuts); the surface finish is governed by separate finish standards (e.g. ISO 4042 for electroplating). For corrosion testing, the relevant document is ISO 9227 (neutral salt spray).