When Cheese Head Screws are required in A2 Stainless Steel, the alternative grades and the trade-offs between them matter as much as the dimensions. This page covers both, plus mechanical and corrosion data.
Why Choose A2 Stainless Steel for Cheese Head Screws
The most common stainless grade for indoor and general outdoor fasteners. For cheese head screws, this matters when good general corrosion resistance is the primary requirement.
Mechanical & Physical Properties
| Grade designation | A2-70 (304) |
|---|---|
| Magnetic response | Largely non-magnetic |
| Service temperature | approx. -200 °C to +400 °C |
| Corrosion characteristic | Good general corrosion resistance |
Corrosion Behavior in Service
A2 (304) gives excellent atmospheric and most-water corrosion resistance and is the most common stainless for Cheese Head Screws in indoor and general outdoor service. In chloride-bearing environments (marine air, road salt, swimming pools) consider stepping up to A4 (316).
Galvanic & Galling Considerations
Two important notes for stainless cheese head screws: (1) stainless can gall on stainless threads under load — use a thread lubricant or anti-galling compound, especially for M6 and below; (2) when joined to aluminum or galvanized steel, stainless can drive galvanic corrosion of the less-noble metal in wet service — isolate with a coating or sleeve where appropriate.
Sizes of Cheese Head Screws Available in A2 Stainless Steel
| Size | Pitch (mm) | Head diameter dk (mm) | Head height k (mm) | Cross recess | Reference standard |
|---|---|---|---|---|---|
| M1.6 | 0.35 | 3.0 | 1.6 | PH0 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M2 | 0.4 | 3.8 | 2.0 | PH1 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M2.5 | 0.45 | 5.0 | 2.5 | PH1 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M3 | 0.5 | 5.5 | 3.0 | PH1 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M3.5 | 0.6 | 6.0 | 3.5 | PH2 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M4 | 0.7 | 7.0 | 4.0 | PH2 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M5 | 0.8 | 8.5 | 5.0 | PH2 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M6 | 1.0 | 10.0 | 6.0 | PH3 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M8 | 1.25 | 13.0 | 8.0 | PH3 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |
| M10 | 1.5 | 16.0 | 10.0 | PH4 | ISO 7048 / DIN 7985 (cross) / ISO 1207 (slotted) |