M6 Socket Head Cap Screws is the m6-thread variant of Socket Head Cap Screws manufactured to ISO 4762 / DIN 912. This page focuses on the data engineers reach for at the bench: dimensional values for the M6 size, the spanner/drive that fits, and the assembly data you need to install it.
M6 Dimensional Row (ISO 4762 / DIN 912)
| Size | Pitch (mm) | Head diameter dk (mm) | Head height k (mm) | Hex key s (mm) | Socket depth t min (mm) | Reference standard |
|---|---|---|---|---|---|---|
| M6 | 1.0 | 10.0 | 6.0 | 5.0 | 3.0 | ISO 4762 / DIN 912 |
Spanner & Drive for M6 Socket Head Cap Screws
The hex socket for M6 Socket Head Cap Screws is shown in the spec table — use the matching Allen / hex key (an ISO 2936 hex key set covers the full range). A T-handle Allen key gives the best feel for setting preload by feel; for production work use a torque-controlled driver.
Hole Sizes for M6
| Coarse-thread pitch (ISO 724) | 1 mm |
|---|---|
| Through-hole / clearance (ISO 273 medium) | 6.6 mm |
| Tapping drill, coarse thread | 5 mm |
Tightening Torque for M6
| Class 8.8 (dry, ~µ 0.125) | ≈ 10 Nm |
|---|---|
| Class 10.9 (dry, ~µ 0.125) | ≈ 14 Nm |
| Class 12.9 (dry, ~µ 0.125) | ≈ 17 Nm |
Indicative dry-joint values. Lubrication can lower the required torque by 15–25%. Always confirm against the joint design, especially when going up a strength class.
Common Applications for M6 Socket Head Cap Screws
M6 Socket Head Cap Screws are commonly specified for machine assembly, general engineering, plant maintenance and OEM equipment.
Installation Tips for M6 Socket Head Cap Screws
- Use a quality Allen key fully seated in the socket — partial engagement is the most common cause of stripped sockets at this size.
- For countersunk and button-head variants, chamfer the through-hole to seat the head flush without preloading the head/shank fillet.
When to Step Up or Down from M6
When the joint preload approaches the proof load of M6 class 8.8, step up to M8 class 8.8 (or move to M6 class 10.9). When the joint is over-specified, M5 often saves weight and cost without losing the safety margin.